The one who has tasted the freedom to drive ATV on rough can hardly accept it’s only and one disadvantage–it cannot float. After three years product development it is changed forever. The Amphibear kit gives you never seen safety on ice and extended reach for crossing small water obstacles.

Your ATV can be made amphibous with Amphibear kit

• Makes you ATV Amphibious with inflatable pontoons

• Totally foldable to racks when deflated

• Does not extend cross dimensions of your vehicle when deflated

• Bolt-on kit, no cutting or fabricating is required (for most ATV models)

Can be installed to most of ATV-s (with front and rear metal frame racks and ability to cross water deeper than 14"). For complete installation and use requires:

• Rear and front metal frame racks

• Rear winch mount (winch is not needed)

• Front bumper (from metal tubes)

• Portable 12V inflator, suggested with rapid inflation/deflation valves

• Suggested: mud paddles for extra grip in water

SPECIFICATIONS

Requirements to ATV

• Full loaded ATV weight less than 882 lb (400 kg)

• Allowed water depth in normal ride at least 14" (35 cm)

• Metal racks (1) fixed to ATV frame and allow shift of all weight of ATV (do not mix it with your ATV racks load limitations, what can be related to suspension load limit)

• Front metal tube bumper (2) or other suitable attachment for front pontoon load strap (should stand pull of 662 lb (300 kg)

• Rear winch mount (3) with roller fairlead or other suitable attachment for rear pontoon load strap (should stand pull of 662 lb (300 kg)

Amphibear kit transport package:

• Weight 66lb (30 kg)

• Dimensions LxWxH 41x14x8" (105x35x20cm)

Amphibear kit assembly to ATV racks

• Frame assembly width adjustable 10-33" (25-85cm), step of 4" (10 cm)

• Fixings extend over rack 3-5" (8-13cm) in front and rear.

Attached kit in travel position (both frames on racks pontoons deflated)

• Installed and folded kit fills your ATV both racks

• HxLxW: 6x20x40" (15x50x100 cm)

Attached kit in floating position (both frames extended and pontoons inflated)

• In floating position frame extends about 20" (50 cm) in front and rear

• Inflated pontoon width is 60" (150 cm) and pontoon extends in floating position ATV 36" (90 cm) in both ends.

• Inflated pontoon height is 22" (55 cm), suggested ground clearance in float position is 6" (15 cm)

• Fully loaded pontoons will have waterline in 8" (20 cm),

• Floating ATV waterline will be 14" (35 cm)

• One pontoon inflation/deflation time about 10 min, with rapid function (depends on inflator model)

Register your interest before mass production is started! E-mail me:

PACKAGE CONTAINS:

• 2 metal frames (assembled from 5 metal beams) hinged in middle with pontoons in half-bag (pontoons with inflation hose)

• 8 fasteners for frame assembly to ATV rack

• 2 load straps tensors

• Needed smaller fasteners

See video of float test here (4.8M)

Go anywhere, any season!